RMSTATOR HIGH OUTPUT STATOR
You must re-install your original connector (see picture).
Once your connector is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
Pick up pulsar coil included
Higher grade of electronic components.
Highest grade copper windings, resistant to 200 degrees Celsius.
All products shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Before installing your new stator
Check the AC output of the stator.
Replace any burned or corroded connectors on stator and regulator/rectifier
Check and repair any melted wiring.
Use hi-temp dielectric grease on all connectors
When re-installing your original connector, The three alternator wires (same color) have no specific order.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
ALTERNATOR Between each white 0.4 ohms ±20%
PICK UP COIL White to Grey 500 ohms ±20%
Yamaha Viking 700 2014
Yamaha Viking 700 EPS 2014
Yamaha YXR 700 Rhino 2011-2013
Yamaha YXR 700 Rhino FI 2008-2009, 2011
Yamaha YXR 700 Rhino FI Special Edition 2008-2009, 2012
Yamaha YXR 700 Rhino FI Special Edition II 2008-2009